Pumps for above-ground pools

To choose between pump models, you should primarily look at the type of motor:1 speed, 2 speeds or variable speed. A pump 1 speed It is simple and inexpensive to buy, but it consumes more electricity because it always runs at full power. A pump 2 speeds. This allows the low speed to be used at night for lower-cost filtration, and the high speed during the day for greater efficiency (cleaning, heating, backwashing). The pump variable speed It offers the most precise flow adjustment: it can be adjusted exactly according to the needs of the pool, making it very quiet and much more energy-efficient in the long term, even if it is more expensive to buy.

Fill in the basket/scroll ensure a water level Once the skimmer is full, tighten the lid (clean/greased seals), open the valves, start and bleed the air filtered. If bubbles persist: check air intakes (lid, fittings).

Weekly: empty the pump basket,

Start of season and end of season: control joints And leaks monitor the pressure through the filter.

A pool pump typically consumes between 500 and 1,500 watts, depending on the motor's power and model. A 1 HP pump used 8 hours a day can cost between $25 and $60 per month, depending on the electricity rate. Variable-speed pumps consume significantly less energy and can reduce your bill by 50 to 70%.

Generally, a residential pool pump should have a power rating between 3/4 HP and 2 HP, depending on the size of the pool. The most common standard for pools sold in Quebec is a 1.5 HP pump. If you feel your pump isn't powerful enough (cloudy water, poor circulation, skimmer not properly collecting debris), start by checking that the filter isn't full or clogged. If everything is clean and the problem persists, it's recommended to have the pump motor checked by a technician.

Start by turning off the power and closing the valves. Open the pump basket lid, remove the basket, and empty it of leaves and debris. Rinse it with clean water to remove sand and dirt. Also check the inside of the housing for any trapped debris. Replace the basket, ensuring the lid seal is clean, and then close it tightly. Regular cleaning prevents the pump from straining and improves water circulation.

To disassemble a Hayward pump, begin by disconnecting the power and closing the valves. Next, unscrew the unions or clamps that connect the pump to the piping. Unscrew the strainer screws to access the impeller. Carefully remove the parts, noting the order of assembly. Always work with the pump switched off and in a dry environment to prevent damage and electrical hazards.